Siemens SINAMICS V20

Parameter list
8.2 Parameter list
SINAMICS V20 Converter
Operating Instructions, 10/2019, A5E34559884-012
227
Parameter
Function
Range
Factory
default
Can be
changed
Scaling
Data
set
Data
type
Acc.
Level
P0727[0...2]
Selection of 2/3-wire
method
0 - 3 0 C, T - CDS U16 2
Determines the control method using the terminals. This parameter allows the selection of the control
philosophy. The control philosophies exclude each other.
2/3-wire control allows to start, stop and reverse the converter in one of the following ways:
• 2-wire control with Siemens standard control
using ON/OFF1 and REV as permanent signals
• 2-wire control with Siemens standard control
using ON/OFF1 and ON_REV/OFF1 as permanent signals
• 2-wire control
using ON_FWD and ON_REV as permanent signals