Siemens SINAMICS V20 - Page 281

Parameter list
8.2 Parameter list
SINAMICS V20 Converter
Operating Instructions, 10/2019, A5E34559884-012
279
Parameter
Function
Range
Factory
default
Can be
changed
Scaling
Data
set
Data
type
Acc.
Level
P2001[0...2]
Reference voltage [V]
10 - 2000
1000
T
-
DDS
U16
3
Full-scale output voltage (i.e. 100 %) used over serial link (corresponds to 4000H).
Example:
Note:
Changes to P2001 result in a new calculation of P2004.
P2002[0...2]
Reference current [A]
0.10 - 10000.0
0.10
T
-
DDS
Float
3
Full-scale output current used over serial link (corresponds to 4000H).
Example:
If a BICO connection is made between two parameters, the 'unit' of the parameters (standardized (Hex) or
physical (i.e. A) values) may differ. In this case an automatic conversion to the target value is made.
Dependency:
This parameter is influenced by automatic calculations defined by P0340.
Note:
Changes to P2002 result in a new calculation of P2004.
P2003[0...2]
Reference torque [Nm]
0.10 - 99999.0
0.75
T
-
DDS
Float
3
Full-scale reference torque used over the serial link (corresponds to 4000H).
Example:
If a BICO connection is made between two parameters, the 'unit' of the parameters (standardized (Hex) or
physical (i.e. Nm) values) may differ. In this case an automatic conversion to the target value is made.
Dependency:
This parameter is influenced by automatic calculations defined by P0340.
Note:
Changes to P2003 result in a new calculation of P2004.
P2004[0...2]
Reference power
0.01 - 2000.0
0.75
T
-
DDS
Float
3
Full-scale reference power used over the serial link (corresponds to 4000H).
Example:
If a BICO connection is made between two parameters, the 'unit' of the parameters (standardized (Hex) or
physical (i.e. kW/hp) values) may differ. In this case an automatic conversion to the target value is made.