Siemens SINAMICS V20 - Page 75

Commissioning via the built-in BOP
5.5 Quick commissioning
SINAMICS V20 Converter
Operating Instructions, 10/2019, A5E34559884-012
73
Connection macro Cn007 - External push buttons with analog control
Note that the command sources are pulse signals.
Connection macro settings:
Parameter
Description
Factory default
Default for Cn007
Remarks
P0700[0]
Selection of command source
1
2
Terminals as command source
P1000[0]
Selection of frequency
1
2
Analog setpoint 1
P0701[0]
Function of digital input 1
0
1
OFF hold
P0702[0]
Function of digital input 2
0
2
Forward pulse + ON
P0703[0]
Function of digital input 3
9
12
Reverse pulse + ON
P0704[0]
Function of digital input 4
15
9
Fault acknowledgement
P0727[0] Selection of 2/3-wire method 0 2 3-wire
STOP + Forward pulse + Reverse pulse
P0771[0]
CI: Analog output
21
21
Actual frequency
P0731[0]
BI: Function of digital output 1
52.3
52.2
Converter running
P0732[0]
BI: Function of digital output 2
52.7
52.3
Converter fault active