1. Setup 09.01
1-10 © Siemens AG, 2001. All rights reserved
SINUMERIK 802D Milling ISO Dialect M (ISF) - Edition 09.01
Activate ISO Dialect M, G291
N10 G291
G291 Activate ISO Dialect M NC programming
language
G290 Activate SIEMENS NC programming language
Machine OEM
Please observe the details supplied by the machine OEM
before switching on the power and when switching from
the Siemens programming language into the ISO dialect
programming language.
• The active tool,
• the tool offsets, and
• zero offsets
are retained when the ISO dialect programming language is
active.
ISO dialekt
The "ISO Dialect M" NC programming language is a second
programming language with a G Code command set.
To Next Page
Loading...
Need help?
General
