Siemens SINUMERIK 802D Short Guide

2. Create/Edit Program 09.01
2-16 © Siemens AG, 2001. All rights reserved
SINUMERIK 802D Milling ISO Dialect M (ISF) - Edition 09.01
Copy/Insert/Delete Block
Copy/insert
Prerequisite:
Existing program is open.
Use the cursor to select the
required block or the position
where the marking is to start.
Mark
block
Start marking.
Use the cursor to select the
end point of the marking.
Copy
block
Copy the marked text
Place the cursor at the required
insertion point.
Insert
block
Insert copied selection
Notes
• Blocks are always copied behind the cursor.
• Blocks can also be copied and inserted between
different programs.
Delete
Prerequisite:
Existing program is open.
Use the cursor to select the
required block or the position
where the marking is to start.
Mark
block
Start marking.
Use the cursor to select the
end point of the marking
Delete
block
Delete marked text

Siemens SINUMERIK 802D Specifications

General

Brand	Siemens
Model	SINUMERIK 802D
Category	Control Unit
Language	English