Siemens SINUMERIK 802D Short Guide

09.01 3. Execute/Correct Program
© Siemens AG, 2001. All rights reserved
3-21
SINUMERIK 802D Milling ISO Dialect M (ISF) - Edition 09.01
Correct Program
NC stop
Prerequisite:
Program is being executed in Automatic.
Stop program.
Program
correction
Select Program correction.
Select block with the cursor
and correct it.
NC start is used to continue the
program at the interrupt point.
Notes
• After program interrupt (NC stop), the tool can be
moved in manual operation (jog) away from the
contour. The control stores the coordinates of the
interrupt point.
• Corrections can only be made to those blocks that the
control has not yet imported.
NC reset
Prerequisite:
Program is being executed in Automatic.
Interrupt program
Program
correction
Select Program correction.
Select block with the cursor
and correct it.
NC start is used to start the
program at the beginning
Note
The control interrupts the execution should a system error
occur in the parts program.

Siemens SINUMERIK 802D Specifications

General

Brand	Siemens
Model	SINUMERIK 802D
Category	Control Unit
Language	English