© Siemens AG, 2001. All rights reserved 0-5
SINUMERIK 802D Milling ISO Dialect M (ISF) - Edition 09.01
09.01 General
Introduction
How to use this document
This document is a short guide describing
all the important operating and programming steps.
For detailed descriptions of operating and programming the
SINUMERIK 802D, refer to:
• User Manual, Turning,
Order No. 6FC5698-2AA00-0BP0
• User Manual, Milling,
Order No. 6FC5698-2AA10-0BP0
Method of description
The method of description is as follows:
Operating
Prerequisite
Operating sequence
Programming
Programming the function
Meaning of the parameters
Descriptive picture with an example of a workpiece
To Next Page
Loading...
