Siemens SINUMERIK 808D ADVANCED Parameter Manual

20173 SURF_VELO_TOL C09 -
mm/min Maximum permitted deviation of the path feed on compression
with COMPSURF
DOUBLE PowerOn
-
808d-me42 - 1000.0, 1000.0,
1000.0, 1000.0,
1000.0, 1000.0,
1000.0, 1000.0...
0.0 - 1/1 M
808d-me62 - 1000.0, 1000.0,
1000.0, 1000.0,
1000.0, 1000.0,
1000.0, 1000.0...
0.0 - 1/1 M
808d-te42 - 1000.0, 1000.0,
1000.0, 1000.0,
1000.0, 1000.0,
1000.0, 1000.0...
0.0 - 0/0 S
808d-te62 - 1000.0, 1000.0,
1000.0, 1000.0,
1000.0, 1000.0,
1000.0, 1000.0...
0.0 - 0/0 S
808d-mte40 - 1000.0, 1000.0,
1000.0, 1000.0,
1000.0, 1000.0,
1000.0, 1000.0...
0.0 - 7/2 M
808d-mte60 - 1000.0, 1000.0,
1000.0, 1000.0,
1000.0, 1000.0,
1000.0, 1000.0...
0.0 - 7/2 M
Description: The value specifies the maximum permitted deviation for compression for the path feed.
The larger the value, the more short blocks can be compressed into one long block.
20191 IGN_PROG_STATE_ASUP EXP K1
- Do not display interrupt program execution on OPI DWORD NEW CONF
-
- - 0, 0, 0, 0, 0, 0, 0, 0... 0 0x7FFFFFFF 2/2 M
Description: If the ASUB is started, OPI variables
progStatus and chanStatus do not change, i.e. the HMI does not see this normally short
program execution.
Bit 0 is assigned to interrupt channel 1.
Bit 1 is assigned to interrupt channel 2, etc.
Korrespondiert mit:
MD11602 $MN_ASUP_START_MASK
MD20115 $MC_IGNORE_REFP_LOCK_ASUP
MD20116 $MC_IGNORE_INHIBIT_ASUP
MD20117 $MC_IGNORE_SINGLEBLOCK_ASUP
MD20194 $MC_IGNORE_NONCSTART_ASUP
20192 PROG_EVENT_IGN_PROG_STATE EXP -
- Do not display the Prog-Event on OPI DWORD NEW CONF
-
- - 0x0, 0x0, 0x0, 0x0,
0x0, 0x0, 0x0, 0x0...
0 0x3F 2/2 M
Machine data
3.3 Channel-specific machine data
Parameter Manual
Parameter Manual, 08/2015, 6FC5397-8EP40-0BA1 135

Siemens SINUMERIK 808D ADVANCED Specifications

General

Brand	Siemens
Model	SINUMERIK 808D ADVANCED
Category	Control Unit
Language	English