Siemens SINUMERIK 808D ADVANCED

808d-te42 3 0.0, 0.0, 0.0, 0.0, 0.0,
0.0, 0.0, 0.0, 0.0, 0.0,
0.0, 0.0, 0.0,...
- 0.0 0/0 S
808d-te62 3 0.0, 0.0, 0.0, 0.0, 0.0,
0.0, 0.0, 0.0, 0.0, 0.0,
0.0, 0.0, 0.0,...
- 0.0 0/0 S
808d-mte40 3 0.0, 0.0, 0.0, 0.0, 0.0,
0.0, 0.0, 0.0, 0.0, 0.0,
0.0, 0.0, 0.0,...
- 0.0 7/7 U
808d-mte60 3 0.0, 0.0, 0.0, 0.0, 0.0,
0.0, 0.0, 0.0, 0.0, 0.0,
0.0, 0.0, 0.0,...
- 0.0 7/7 U
Description: Lower limit of the offset value which can be specified through synchronous actions via
the system variable $AA_TOFF.
This limit value acts on the active correction through $AA_TOFF in the minus direction.
This limit value is only effective if $MC_TOFF_MODE Bit6 = 1 is set.
Über die Systemvariable $AA_TOFF_LIMIT kann abgefragt werden, ob sich der
Korrekturwert im Grenzbereich befindet.
42974 TOCARR_FINE_CORRECTION C08 -
- Fine offset TCARR ON / OFF BOOLEAN Immediately
-
808d-me42 - FALSE, FALSE,
FALSE, FALSE,
FALSE, FALSE,
FALSE, FALSE...
0 - 0/0 S
808d-me62 - FALSE, FALSE,
FALSE, FALSE,
FALSE, FALSE,
FALSE, FALSE...
0 - 0/0 S
808d-te42 - FALSE, FALSE,
FALSE, FALSE,
FALSE, FALSE,
FALSE, FALSE...
0 - 0/0 S
808d-te62 - FALSE, FALSE,
FALSE, FALSE,
FALSE, FALSE,
FALSE, FALSE...
0 - 0/0 S
808d-mte40 - FALSE, FALSE,
FALSE, FALSE,
FALSE, FALSE,
FALSE, FALSE...
0 - 7/7 U
808d-mte60 - FALSE, FALSE,
FALSE, FALSE,
FALSE, FALSE,
FALSE, FALSE...
0 - 7/7 U
Description: TRUE:
On activating an orientable tool holder, the fine offset values are considered.
FALSE:
On activating an orientable tool holder, the fine offset are not considered.
NC setting data
Parameter Manual
338 Parameter Manual, 08/2015, 6FC5397-8EP40-0BA1