Siemens SINUMERIK 808D ADVANCED - Page 104

Machine data
2.3 Channel-specific machine data
Parameter Manual
104 Operating Instructions, 08/2013, 6FC5397-8EP40-0BA0
- Tool length offset not active
- Transformation not active
- No coupled-motion axis groupings active
- No tangential correction active
- No master value coupling active
- No axial revolutional feedrate active
- Path revolutional feedrate with master spindle (default)
Bit 0 (LSB) = 1: Standard value for Powerline and Solutionline systems
Initial setting after ramp-up:
- G codes acc. to MD20150 $MC_GCODE_RESET_VALUES
- Tool length offset active acc. to MD20120 $MC_TOOL_RESET_VALUE, MD20130
$MC_CUTTING_EDGE_RESET_VALUE and MD20132 $MC_SUMCORR_RESET_VALUE
- Transformation active acc. to MD20140 $MC_TRAFO_RESET_VALUE
- Geometry axis replacement acc. to MD20118 $MC_GEOAX_CHANGE_RESET
- No coupled-motion axis groupings active
- No tangential correction active
Initial setting after reset or end-of-part-program:
Depending on MD20152 $MC_GCODE_RESET_MODE the current settings are retained
for the G groups or the initial settings stored in
MD20150$MC_GCODE_RESET_VALUES are set.
Initial setting after reset or end-of-part-program
Depending on MD20110 $MC_RESET_MODE_MASK bit 6 to 7 are used for
- Tool length offset
- Transformation
either the actual settings are saved or the initial settings saved in the MDs
are set.
Depending on bits 8 and 9, the current settings of coupled-motion axes or
tangentially corrected axes are either deactivated or retained.
Configured synchronous spindle coupling:
The coupling is deselected depending on the setting in MD21330
$MC_COUPLE_RESET_MODE_1.
Non-configured synchronous spindle coupling:
Depending on bit 10, the coupling is either deactivated or retained.
Depending on bit 14, the basic frame is either retained or deselected.
Bit 1 = 0:
Auxiliary function output (D,T,M) at the PLC for tool selection corresponding
to machine data
MD20120 $MC_TOOL_RESET_VALUE
MD20130 $MC_CUTTING_EDGE_RESET_VALUE
MD20121 $MC_TOOL_PRESEL_RESET_VALUE
MD22550 $MC_TOOL_CHANGE_MODE
When magazine management is active, T, M are not output as auxiliary func-
tions.
The function uses its own communication to output T, M to the PLC, for exam-
ple.
Bit 1 = 1:
Suppress aux. funct. output to PLC on tool selection.
If tool management or magazine management is active, T, M are AVIGNON gener-
ally not output as auxiliary functions.
Bit 2 = 0: