Machine data
2.3 Channel-specific machine data
Parameter Manual
144
Operating Instructions, 08/2013, 6FC5397-8EP40-0BA0
Bit9: 0:
Multiplication with 0.01mm / 0.0001inch is carried out in ISO mode T for G84,
G88 and in standard mode F for G95.
1:
Multiplication with 0.001mm / 0.00001inch is carried out in ISO mode T for
G84, G88 and in standard mode F for G95.
Bit10: 0:
With M96 Pxx, the program programmed with Pxx is always called in the case of
an interrupt
1:
With M96 Pxx, CYCLE396.spf is always called in the case of an interrupt
Bit11: 0:
With G54 Pxx, only G54.1 is displayed
1:
With G54 Pxx, the programmed program is displayed after the point, e.g.
G54.48
Bit12: 0:
When the subroutine defined with M96 Pxx is called, $P_ISO_STACK is not mod-
ified
1:
When the subroutine defined with M96 Pxx is called, $P_ISO_STACK is incre-
mented
Bit13: 0:
G10 is executed without internal STOPRE
1:
G10 is executed with internal STOPRE
Bit14: 0:
ISO_mode T: No alarm if a cutting edge has been programmed in the T command.
1:
ISO mode T: Alarm 14185 if a cutting edge has not been pro-
grammed in the T command.
Bit 15: 0:
ISO_mode M: G51 Scale, the axial scale factors I, J, K work with 'pocket cal-
culator notation' as programmed.
1:
ISO_mode M: G51 Scale, the axial scale factors I, J, K with 'pocket cal-
culator notation', are multiplied by the value in MD22910
$MC_WEIGHTING_FACTOR_FOR_SCALE.
To Next Page
Loading...
