Parameter Manual
Operating Instructions, 08/2013, 6FC5397-8EP40-0BA0
143
Machine data
2.3 Channel-specific machine data
Description: This machine data is used to influence functions in ISO mode.
Bit0: 0:
ISO mode T: "A" and "C" are interpreted as axes. If contour definition has
been programmed, "A" or "C" must be preceded by a comma.
1:
"A" and "C" in the part program are always interpreted as a contour defini-
tion. An axis "A" or "C" is not allowed.
Bit1: 0:
ISO mode T: G10 P < 100 tool geometry
P > 100 tool wear
1:
G10 P < 10000 tool geometry
P > 10000 tool wear
Bit2: 0:
G04 dwell time: always [s] or [ms]
1:
If G95 is active, in spindle revolutions
Bit3: 0:
Errors in ISO scanner lead to an alarm
1:
Errors in ISO scanner are not output, the block is transferred to the Siemens
translator.
Bit4: 0:
G00 is traversed with the current exact stop - continuous-path mode G code
1:
G00 is always traversed with G09
Bit5: 0:
Modulo rotary axis is positioned at the shortest possible distance
1:
Direction of rotation of modulo rotary axis depends on sign
Bit6: 0:
Only 4-digit program number allowed.
1:
8-digit program number allowed. If the program number has less than 4 digits,
it is expanded to 4 digits with 0.
Bit7: 0:
Axis programming for geometry axis exchange/parallel axes is compatible with
ISO mode.
1:
Axis programming for geometry axis exchange/parallel axes in ISO mode is com-
patible with Siemens mode.
Bit8: 0:
With cycles, the F value transferred is always interpreted as a feedrate.
1:
With threading cycles, the F value transferred is interpreted as a pitch.
20734 EXTERN_FUNCTION_MASK N12 -
- Function mask for external language DWORD Reset
-
- - 0x4800 0 0xFFFF 1/1
Siemens Controls
To Next Page
Loading...
Need help?
General
