Siemens SINUMERIK 808D ADVANCED - Page 177

Parameter Manual
Operating Instructions, 08/2013, 6FC5397-8EP40-0BA0
177
Machine data
2.3 Channel-specific machine data
Description: The part counters can be configured with this machine data.
Note: with bit 0 = 1 and $AC_REQUIRED_PARTS smaller than 0 all workpiece
counts
activated in this MD are frozen at the status reached.
Meaning of the individual bits:
Bits 0 - 3:Activating $AC_REQUIRED_PARTS
------------------------------------------------------------------------
Bit 0 = 1:Counter $AC_REQUIRED_PARTS is activated
Further significance of bits 1-3 only when bit 0 =1 and $AC_REQUIRED_PARTS >
0:
Bit 1 = 0:Alarm/VDI output if $AC_ACTUAL_PARTS corresponds to
$AC_REQUIRED_PARTS
Bit 1 = 1:Alarm/VDI output if $AC_SPECIAL_PARTS corresponds to
$AC_REQUIRED_PARTS
Bit 2Reserved!
Bit 3Reserved!
Bits 4 - 7:Activating $AC_TOTAL_PARTS
-------------------------------------------------------------------------
Bit 4 = 1:Counter $AC_TOTAL_PARTS is active
Further meaning of bits 5-7 only when bit 4 =1 and $AC_REQUIRED_PARTS > 0:
Bit 5 = 0:Counter $AC_TOTAL_PARTS is incremented by 1 with a VDI output of
M02/M30
Bit 5 = 1:Counter $AC_TOTAL_PARTS is incremented by 1 with output of the M
command from MD PART_COUNTER_MCODE[0]
Bit 6 = 0:$AC_TOTAL_PARTS also active with program test/block search
Bit 7 = 1:counter $AC_TOTAL_PARTS is incremented by 1 when jumping back with
GOTOS
Bits 8 - 11:Activating $AC_ACTUAL_PARTS
-------------------------------------------------------------------------
Bit 8 = 1:Counter $AC_ACTUAL_PARTS is active
Further significance of bits 9-11 only when bit 8 =1 and $AC_REQUIRED_PARTS >
0:
Bit 9 = 0:Counter $AC_ACTUAL_PARTS is incremented by 1 with a VDI output of
M02/M30
Bit 9 = 1:Counter $AC_ACTUAL_PARTS is incremented by 1 with output of the M
command from MD PART_COUNTER_MCODE[1]
Bit 10 = 0:$AC_ACTUAL_PARTS also active with program test/block search
Bit 10 = 1:No machining $AC_ACTUAL_PARTS with program test/block search
Bit 11 = 1:counter $AC_ACTUAL_PARTS is incremented by 1 when jumping bakc
with GOTOS
Bit 12 - 15:Activating $AC_SPECIAL_PARTS
-------------------------------------------------------------------------
Bit 12 = 1:Counter $AC_SPECIAL_PARTS is active
Further significance of bits 13-15 only when bit 12 =1 and $AC_REQUIRED_PARTS
> 0:
Bit 13 = 0:Counter $AC_SPECIAL_PARTS is incremented by 1 with a VDI output
27880 PART_COUNTER C09 K1
- Activation of workpiece counter DWORD Reset
-
- - 0x901 0 0x0FFFF 1/1
Siemens Controls