Siemens SINUMERIK 808D ADVANCED User Manual

Parameter Manual
Operating Instructions, 08/2013, 6FC5397-8EP40-0BA0
213
Machine data
2.4 Axis-specific machine data
Description: Maximum velocity at which the axis can permanently travel. The value limits
both the positive and the negative axis velocity. The axis traverses at this
velocity, if rapid traverse has been programmed.
Depending on the MD30300 $MA_IS_ROT_AX, the maximum rotary or linear axis
velocity has to be entered.
In the machine data, the dynamic behavior of the machine and drive and the
limit frequency of the actual value acquisition must be taken into account.
Description: The axis velocity entered applies when the rapid traverse override key is
pressed in JOG mode and when the axial feedrate override is set to 100%.
The value entered must not exceed the maximum permissible axis velocity
(MD32000 $MA_MAX_AX_VELO).
This machine data is not used for the programmed rapid traverse G0.
MD irrelevant to:
Operating modes AUTOMATIC and MDI
Related to:
MD32000 $MA_MAX_AX_VELO (maximum axis velocity)
MD32040 $MA_JOG_REV_VELO_RAPID
(revolutional feedrate for JOG with rapid traverse override)
NC/PLC interface signal DB3200 DBX1000.5,1004.5,1008.5 (Rapid traverse over-
ride)
NC/PLC interface signal DB3200 DBX4 (Feedrate override A-H)
32000 MAX_AX_VELO A11, A04 M3,TE1,TE3,W6,Z3,H1,K3,M
1,P2,A3,B2,G2,H2,S1,V1,W1
mm/min, rev/
min
maximum axis velocity DOUBLE NEW CONF
CTEQ
808d-me42 - 10000., 10000.,
10000., 36000.
(0./ 0.) (1.e300/ 1.e300) 2/2
808d-me62 - 10000., 10000.,
10000., 36000.,
36000.
(0./ 0.) (1.e300/ 1.e300) 2/2
808d-te42 - 10000., 10000.,
10000., 36000.
(0./ 0.) (1.e300/ 1.e300) 2/2
808d-te62 - 10000., 10000.,
10000., 36000.,
36000....
(0./ 0.) (1.e300/ 1.e300) 2/2
32010 JOG_VELO_RAPID A11, A04, - H1
mm/min, rev/
min
Rapid traverse in jog mode DOUBLE Reset
CTEQ
808d-me42 - 10000., 10000.,
10000., 36000.
(0./ 0.) (1.e300/ 1.e300) 2/2
808d-me62 - 10000., 10000.,
10000., 36000.,
36000.
(0./ 0.) (1.e300/ 1.e300) 2/2
808d-te42 - 10000., 10000.,
10000., 36000.
(0./ 0.) (1.e300/ 1.e300) 2/2
808d-te62 - 10000., 10000.,
10000., 36000.,
36000....
(0./ 0.) (1.e300/ 1.e300) 2/2
Siemens Controls

Siemens SINUMERIK 808D ADVANCED Specifications

General

Brand	Siemens
Model	SINUMERIK 808D ADVANCED
Category	Control Unit
Language	English