Siemens SINUMERIK 808D ADVANCED - Page 24

Machine data
2.1 Display machine data
Parameter Manual
24 Operating Instructions, 08/2013, 6FC5397-8EP40-0BA0
Description:
User-oriented G group for position display (ext. language)
Description: User-oriented G group for position display (ext. language)
Description: User-oriented G group for position display (ext. language)
Description: User-oriented G group for position display (ext. language)
Description: User-oriented G group for position display (ext. language)
Description: Coordinate position of the machine
Description: Enable 802 contour definition programming
Description: Enable the location number in the tool list
310 FG_GROUP1 --
- User-oriented G group for position display (external language) BOOLEAN Immediately
-
- 0 1 1 1000 7/3
311 FG_GROUP2 --
- User-oriented G group for position display (external language) BOOLEAN Immediately
-
- 0 2 1 1000 7/3
312 FG_GROUP3 --
- User-oriented G group for position display (external language) BOOLEAN Immediately
-
- 0 8 1 1000 7/3
313 FG_GROUP4 --
- User-oriented G group for position display (external language) BOOLEAN Immediately
-
- 0 9 1 1000 7/3
314 FG_GROUP5 --
- User-oriented G group for position display (external language) BOOLEAN Immediately
-
- 0 19 1 1000 7/3
330 CMM_POS_COORDINATE_SYSTEM --
- Coordinate position of the machine axis BYTE Immediately
-
-0 0 0 7 7/3
331 CONTOUR_MASK --
- Enable 802 contour definition programming BYTE Immediately
-
-0 1 0 1 3/3
332 TOOL_LIST_PLACE_NO --
- Enable the location number in the tool list BOOLEAN Immediately
-
-0 0 0 1 3/3