Siemens SINUMERIK 808D ADVANCED - Page 23

Parameter Manual
Operating Instructions, 08/2013, 6FC5397-8EP40-0BA0
23
Machine data
2.1 Display machine data
Description: 0: Input of absolute values as radius value
Work offsets always in radius
Tool lengths always in radius
Tool wear always in radius
1: Position display in diameter
Distance to go in diameter
Absolute paths in diameter
Description: 0: Input in radius
1: Input in diameter
Description: User-oriented G group for position display
Description: User-oriented G group for position display
Description: User-oriented G group for position display
Description: User-oriented G group for position display
Description: User-oriented G group for position display
291 CTM_CROSS_AX_DIAMETER_ON --
- Diameter display active for transv. axes BYTE Immediately
-
-0 1 0 1 4/3
292 CTM_G91_DIAMETER_ON --
- Incremental infeed BYTE Immediately
-
-0 1 0 1 7/3
305 G_GROUP1 --
- User-oriented G group for position display BOOLEAN Immediately
-
- 0 1 1 1000 7/3
306 G_GROUP2 --
- User-oriented G group for position display BOOLEAN Immediately
-
- 0 2 1 1000 7/3
307 G_GROUP3 --
- User-oriented G group for position display BOOLEAN Immediately
-
- 0 8 1 1000 7/3
308 G_GROUP4 --
- User-oriented G group for position display BOOLEAN Immediately
-
- 0 9 1 1000 7/3
309 G_GROUP5 --
- User-oriented G group for position display BOOLEAN Immediately
-
- 0 10 1 1000 7/3
Siemens Controls