Machine data
2.2 General machine data
Parameter Manual
70
Operating Instructions, 08/2013, 6FC5397-8EP40-0BA0
Description:
This MD describes the stop behavior of the NCK under certain conditions:
Bit no. Meaning
Bit 0 == 0 :=
No stop if G codes G331/G332 are active and a path motion or G4 has also been
programmed.
Bit 0 == 1 :=
Same behavior as until SW version 6.4, i.e. a stop is possible during G331/
G332.
Bits 1.....15
Not assigned
11550 STOP_MODE_MASK N01 V1
- Defines the stop behavior. DWORD PowerOn
-
-- 0 0 0x1 2/2
To Next Page
Loading...
