The machine control panel is mounted from the rear with special tension jacks supplied with
the panel.
Operator controls
● Operating mode and function keys:
– 49 keys with assigned LEDs
– Direction keys for milling machines with rapid traverse override (key covers for direction
keys for turning machines are supplied)
– Key type: Mechanical short-stroke keys
● Feed control with override feed/rapid traverse (rotary switch with 23 positions)
● Key-operated switch (four positions and three different keys)
Interfaces
● PLC I/O Interface (data transmission rate: 100 Mbit/s)
● Nine customer-specific inputs (e.g. for illuminated pushbuttons)
● Six customer-specific outputs
● Handwheel connection
Expansion slots
Six slots for control devices (d = 16 mm)
Additional cable set required for control devices: Spare parts and accessories (Page 127)
Connectable components
7.2 MCP 310C PN
PPU
112 Manual, 01/2014, 6FC5397-2DP40-3BA3
To Next Page
Loading...
Need help?
General
