Siemens SINUMERIK 828D PPU Series - Connection

7.4.3 Connection
Electrical connection diagram
The handheld handwheel is connected via a flange socket using the spiral connection cable.
You will find article numbers for the recommended flange socket in Chapter Spare parts and
accessories (Page 154).
6KLHOG
1RWDVVLJQHG
;8
%
9'&s
ZKLWH
EURZQ
JUHHQ
\HOORZ
JUD\
SLQN
/HJHQG
ZV
EU
JQ
JH
JU
UV
ZV
EU
JQ
JH
JU
UV









56$
$
$
%
%
;9
;$
;$
;%
;%
Note
If a connected handwheel triggers pulses while in the idle position or when there is only
minimal contact, connect it the opposite way round to what is stated on the label.
Swap:
● The wires of terminal A with those of terminal /A
● The wires of terminal B with those of terminal /B
Connectable components
7.4 Electronic handwheel
PPU
152 Manual, 01/2014, 6FC5397-2DP40-3BA3