● Only use memory cards that have been approved by Siemens for use with SINUMERIK.
Even though SINUMERIK follows general industry standards for memory cards, it is
possible that memory cards from some manufacturers will not function perfectly in this
device or are not completely compatible with it (you can obtain information on compatibility
from the memory card manufacturer or supplier).
● For SINUMERIK 828D, only the memory card (2 GB) with order number
6FC5313-5AG00-0AA2 is permitted.
NOTICE
CompactFlash card system
● The CompactFlash card always comes formatted! You must not reformat it under any
circumstances!
● To ensure that the system CompactFlash card functions properly, the card must not
be repartitioned.
● In the event of a defect, the system software card must be replaced.
For information about restoring your system using an empty CompactFlash card, refer
to the Service Manual.
2.9.2 Inserting the system CompactFlash Card
Slot and mounting position
① M3 screw
② Metal cover
③ Slot
The CompactFlash card has an edge on the opposite side to the pins. This edge must always
be on the right when inserting the card.
System description
2.9 CompactFlash Cards
PPU
30 Manual, 01/2014, 6FC5397-2DP40-3BA3
To Next Page
Loading...
Need help?
General
