Connectable components
7
7.1 MCP 483C PN
Description
The MCP 483C PN machine control panel enables user-friendly operation of the machine
functions. It can be used with a SINUMERIK 828D control for machine-level operation of milling
and turning machines.
All keys are designed with replaceable caps for machine-specific adaptations. The key caps
can be freely inscribed using laser. Clear key caps can be used as an alternative.
The machine control panel is mounted from the rear with special tension jacks supplied with
the panel.
Operator controls
● Operating mode and function keys:
– 50 keys with assigned LEDs
– Direction keys for milling machines with rapid traverse override
(The key covers for the direction keys for lathes are supplied.)
– Key type: Mechanical short-stroke keys
● Spindle control with override spindle (rotary switch with 16 positions)
● Feed control with override feed/rapid traverse (rotary switch with 23 positions)
● Key-operated switch (four positions and three different keys)
● Emergency-Stop button, two contact pairs (1 NO + 1 NC)
Interfaces
● PLC I/O Interface (data transmission rate: 100 Mbit/s)
● Nine customer-specific inputs (e.g. for illuminated pushbuttons)
● Six customer-specific outputs
● Handwheel connection
Expansion slots
Two slots for control devices (d = 16 mm)
An additional cable set required for control devices: Spare parts and accessories (Page 108)
PPU
Manual, 01/2014, 6FC5397-2DP40-3BA3 93
To Next Page
Loading...
Need help?
General
