Name Description Amoun
t
Article number
Override
Spindle rotary
switch
Spindle/rapid traverse override, electronic
rotary switch 1x16G, T=24, cap, knob,
pointer, spindle and rapid-traverse dials
1 6FC5247–0AF12–1AA0
Override
Feed rotary switch
Override feedrate / rapid traverse electronic
rotary switch 1x23G, T=32, cap, knob,
pointer, feedrate and rapid-traverse dials
1 6FC5247–0AF13–1AA0
Key cap Square, can be labeled by laser, 1 set of 90,
ergo-gray and 20 each of red / green / yellow /
medium gray
1 6FC5248–0AF12–0AA0
Key cap Square, for inscription plates, 1 set of 90,
clear
1 6FC5248–0AF21–0AA0
Cable set For additional MCP control devices, length
500 mm
60 6FC5247-0AA35-0AA0
Accessories pack (for delivery ex works):
Component Description Amount
Keyset Key caps for turning (labeled) 9
Ergo gray key caps (can be labeled) 30
Clear key caps (can be labeled) 30
Yellow backing plate for emergency stop 1
Removing the rotary switch
Note
For the machine control panel, use only electronic rotary switches.
Procedure:
1. Lever the cover ③ off the rotary knob ② (snap-on connection).
2. Remove the nut of collet ① with a wrench (width 10).
3. Remove the entire rotary knob ②.
4. Remove the lock nut ⑤ on the axis of the rotary switch ④ with a wrench (width 14).
Connectable components
7.2 MCP 310C PN
PPU
128 Manual, 01/2014, 6FC5397-2DP40-3BA3
To Next Page
Loading...
