Display elements (rear)
① Ground terminal Detail for ④:
② Feed override X30
③ Spindle override X31
④ PLC I/O Interface X20/X21 connections
⑤ Slot for emergency stop
⑥ Installation locations for additional control devices (d = 16 mm)
⑦ Customer-specific inputs and outputs
⑧ Cover plate
⑨ Ethernet cable strain relief
⑩ LEDs
⑪ Switch for setting the MCP address
⑫ Switch for setting the handwheel signal type
⑬ X60 connection for handwheel, X61 reserved
⑭ Power supply interface X10
Figure 7-3 Rear panel of MCP 483C PN
LEDs for status display
When the system is booting, all three LEDs are lit.
Name Designation Color Description
H1 PowerOK Green Lit: Power supply OK
H2 PNSync Green Lit: System software running, STOP state
Connectable components
7.1 MCP 483C PN
PPU
96 Manual, 01/2014, 6FC5397-2DP40-3BA3
To Next Page
Loading...
