Siemens SINUMERIK 840C - Page 100

04/96

Siemens AG 2001 All rights reserved 6FC5198–jAB40
1–92
SINUMERIK 840C / SIMODRIVE 611–D (DA)
2086* Programmed spindle is slave Reset key
S Setpoint specified for a slave spindle
S Initiate oscillation mode for a slave spindle
S M19 for a slave spindle
S Interlocking of NC Start
S Follow-up mode
S Cancellation of Mode Group Ready
S Processing interrupt
The designated spindle is coupled to its master spindle through a speed setpoint coupling. Setpoints should there-
fore not be specified.
Setpoints should not be specified for the slave spindle.
Applies as from SW 4.4
2087* No synchronous/switching positions defined Reset key
When synchronizing or switching on in relation to a position from PLC.
Interlocking of NC START, MACHINING STOP
An attempt has been made to synchronize master and slave axes/spindles from PLC, or to switch on with
reference to a position, without there being any valid switching or synchronizing positions. Synchronization or
switching on with reference to a position is therefore not possible.
For example, specified positions through the GI input display or G403.
Applies as from SW 4.4
2088* Test stop running Reset key
Alarm description see 1344*
2089* Stop E triggered Reset key
Alarm description see 1348*
2090* Stop D triggered Reset key
Alarm description see 1352*
2091* Stop C triggered Reset key
Alarm description see 1356*
2092* Stop B triggered Reset key
Alarm description see 1360*
2093* Stop A triggered Reset key
Alarm description see 1364*
2094* Tolerance for safe standstill exceeded POWER ON
Alarm description see 1324*
2095* Safe speed exceeded Reset key
Alarm description see 1328*
Scan
Explanation
Explanation
Remedy
Note
Scan
Effect
Explanation
Remedy
Note
Note
Note
Note
Note
Note
Note
Note
Note
1 Alarms
1.5.1 Alarm description