Siemens SINUMERIK 840C - Page 101

04/96

Siemens AG 2001 All rights reserved 6FC5198–jAB40
1–93
SINUMERIK 840C / SIMODRIVE 611–D (DA)
2096* Safe end position exceeded Reset key
Alarm description see 1332*
2097* Failure in a monitoring channel Reset key
Alarm description see 1336*
100001 Connection to keyboard faulty!
When initializing and with every input
Entries through operator panel no longer possible
Connection between operator panel and MMC CPU interrupted
Restore connection
100002 Operator panel: buffer overflow OK softkey
Permanent
MMC crash
Operator panel signals are lost
None
100003 Operator panel interface not ready
Permanently
Operator panel cannot be used
–
Power on
100005 ... (Alarm text is variable) OK softkey
–
Special error text
Depending on operation
–
100006 The area ... is to be terminated OK softkey
–
Application is terminated
Memory required for another application. The operation can be aborted with softkey ABORT.
–
100007 Area ... could not be terminated OK softkey
–
The application has not been terminated
Application is still active
Terminate application
Note
Note
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
1 Alarms
1.5.1 Alarm description