Siemens SINUMERIK 840C - Page 103

04/96

Siemens AG 2001 All rights reserved 6FC5198–jAB40
1–95
SINUMERIK 840C / SIMODRIVE 611–D (DA)
100400 V.24 transfer initiated
On initiation of V.24 transfer
None
Initiation of the V.24 transfer is indicated by the issue of this alarm.
Acknowledge alarm
Alarm 100400 is no longer issued from SW 4.4 and 5.1.
Alarm from SW 6.3, not available any more from SW 4.4
100401 V.24 transfer completed
On completion of the V.24 transfer
None
Completion of the V.24 transfer is indicated by the issue of this alarm.
Acknowledge alarm
Alarm 100401 is no longer issued from SW 4.4 and 5.1
Alarm from SW 6.3, not available any more from SW 4.4
100402 V.24 data output active %0 %1
Serial communication via V.24
None
On successful initiation of data transfer via V.24 this message is output in the message line.
Not applicable
Alarm from SW 6.3
100403 V.24 data output active %0 %1
Serial communication via V.24
None
On successful initiation of data transfer via V.24 this message is output in the message line.
Not applicable
Alarm from SW 6.3
100404 Interface already assigned (Port % 0)
Serial communication via V. 24
Data transmission does not take place.
The serial interface cannot be opened.
Check whether:
specified hardware is available
Baud rate and other settings are correct
interface is already in use
Alarm from SW 6.3
100405 V.24: Call parameter missing/incorrect %0
Seral communication via V.24
None
The interface parameters are incorrect or missing
Check parameters. Permitted parameters are workpiece, program, transmission direction (IN, OUT). Combining
the parameters ”IN” and device type ”Printer” is not allowed.
Alarm from SW 6.3
Scan
Effect
Explanation
Remedy
Remark
Note
Scan
Effect
Explanation
Remedy
Remark
Note
Scan
Effect
Explanation
Remedy
Note
Scan
Effect
Explanation
Remedy
Note
Scan
Effect
Explanation
Remedy
Note
Scan
Effect
Explanation
Remedy
Note
1 Alarms
1.5.1 Alarm description
09/01