Siemens SINUMERIK 840C - Page 135

04/96

Siemens AG 2001 All rights reserved 6FC5198–jAB40
1–127
SINUMERIK 840C / SIMODRIVE 611–D (DA)
120024 Error in data/part program ... OK softkey
The error occurred while transferring the file.
File has not been transferred or only partially.
Syntax error in file structure.
E.g.: % MPF in part program on MMC
Correct the file
120025 Error during job processing OK softkey
Error occurred while transferring the above file.
File has not been transferred or only partially.
Check selected files
Restart transmission
120026 Only possible in Reset OK softkey
The error occurred while transferring the above file.
File was not transferred or only incompletely.
The selected data can be transferred in RESET mode only.
Trigger NC Reset and transfer; start again.
Applies as from SW 4.4
120027 Error in file structure OK softkey
The error occurred while transferring the above file.
File was not transferred or only incompletely.
Syntax error in the file structure. Data after end of list. An item of data follows M02.
Make the corrections in the file.
Applies as from SW 4.4
120028 Cycle disable set OK softkey
The error occurred while a file was being transferred.
File has not been transferred or only partially.
The cycle disable can be set for several cycles.
Remove cycle disable for the cycles concerned.
120029 No communication to NCK
See alarm 110113
120030 Option not available OK softkey
When activating the PG function
S5 package for programming functions cannot be called up.
None
Activate option
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Note
Scan
Effect
Explanation
Remedy
Note
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
1 Alarms
1.5.1 Alarm description