Siemens SINUMERIK 840C - Page 136

04/96

Siemens AG 2001 All rights reserved 6FC5198–jAB40
1–128
SINUMERIK 840C / SIMODRIVE 611–D (DA)
120031 Wrong option password OK softkey
The password entered for the options is incorrect.
The displayed options cannot be altered.
None
Enter correct password.
120032 Error in options list ... OK softkey
When activating option <Nxxx>.
The option in question cannot be activated or deactivated.
None
Call service!
120033 Help text ... not found OK softkey
When operating the I key in the diagnosis alarm basic display.
No alarm/message help texts displayed.
None
Copy the file “MELDINFO” from the standard branch (master control/
language) to user under Installation PC data with the softkey Preset.
The file can then be edited in the user branch and also stored if the password is set.
120034 The hard disk is full OK softkey
PC data preset
Save PLC program
It is not possible to store or create the data.
–
Delete data not required.
120035 PLC program ... cannot be created OK softkey
Save PLC program
The PLC user program could not be saved on the hard disk in the usual way.
–
–
130000 Workpiece/file exists already OK softkey
NEW / CREATE / mask for entering an object name
No new object can be created
Workpiece or file already exists in the data management and cannot be created again.
Enter a new/different name
130001 No element selected OK softkey
PROGRAM or EDIT
A file cannot be processed
Cursor is positioned on “..” or “–”, the file that can be processed has not been selected
Select a file with the cursor
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
1 Alarms
1.5.1 Alarm description