Siemens SINUMERIK 840C - Page 137

04/96

Siemens AG 2001 All rights reserved 6FC5198–jAB40
1–129
SINUMERIK 840C / SIMODRIVE 611–D (DA)
130002 No file type selected OK softkey
NEW / CREATE
New file cannot be created
No element selected in the file type list for creating new files (system error)
New programming / data selector version
130003 No write access for this file OK softkey
EDIT
File cannot be processed
A file has been chosen for which you have no authorization for making changes
Set keyswitch to > 0 setting; enter password in the diagnostics
130004 No read access for this file OK softkey
EDIT
File cannot be processed
A file has been selected for which read access does not exist
Position key switch to position > 3; enter password in diagnosis
130005 There is no standard job list OK softkey
NEW / JOG LIST / CREATE  Create a new job list
Job list cannot be created
The standard job list and/or the “EMPIRICAL VALUES” directory is missing from the data management. When a
new job list is created, this is copied onto the new job list.
Inform system service
130006 Job list does not exist OK softkey
JOB LIST
Job list cannot be processed
No job list exists under a workpiece
Create a job list under the workpiece node using the softkey NEW
130007 Workpiece/file cannot be created OK softkey
NEW / CREATE / mask for entering an object name
No new workpiece or file can be created
Error in data management configuration
memory too small
Incorrect object name (error message from data management create function)
Create more memory
New programming/data management version
130008 Please select workpiece OK softkey
PROGRAMMING
Workpiece cannot be processed
Cursor positioned on “..”, a workpiece has been selected which cannot be processed
Position the cursor on a workpiece name
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
1 Alarms
1.5.1 Alarm description