Siemens SINUMERIK 840C - Page 138

04/96

Siemens AG 2001 All rights reserved 6FC5198–jAB40
1–130
SINUMERIK 840C / SIMODRIVE 611–D (DA)
130009 Please state name OK softkey
NEW / CREATE / mask for entering object name
No new workpiece or file is created
No name was entered
The name was not terminated with input
Enter a name or terminate input with input key
130010 Only NCK-data/part programs can be edited OK softkey
EDIT
File cannot be processed
A file was not selected (recognizable by the length, length 0 also possible) for processing with the editor
Place the cursor on an element with a length entry
130011 Select a workpiece for job list OK softkey
JOB LIST
Job list cannot be processed
The job list of the selected workpiece cannot be processed
Place the cursor on a workpiece
130012 There is no programming system OK softkey
PROGRAMMING
Graphic programming not possible
Graphic programming system does not exist.
Install GRAPHIC PROGRAMMING SYSTEM option.
130013 Name not allowed OK softkey
NEW / CREATE / mask for entering file name
No new object created
Syntax of entered name is incorrect, only alphanumeric characters and “_” permitted
Enter correct name
130014 No workpiece/file may be created OK softkey
Softkey NEW at top level “LOCAL” “GLOBAL”
No new object created
The data management tree does not allow the creation of a directory on this level
–
130015 Access denied OK softkey
PROGRAMMING
Workpiece cannot be processed
Incorrect keyswitch setting
No authorization for processing workpiece
Turn keyswitch to setting 1 or 2; enter password in DIAGNOSIS
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
1 Alarms
1.5.1 Alarm description