Siemens SINUMERIK 840C - Page 139

04/96

Siemens AG 2001 All rights reserved 6FC5198–jAB40
1–131
SINUMERIK 840C / SIMODRIVE 611–D (DA)
130016 No more memory space available OK softkey
NEW / CREATE
Directory/file cannot be created
No memory left to create the directory/file
Workpieces/files which are no longer required can be deleted
130017 Disk full! No graphical programming OK softkey
PROGRAMMING
Workpiece cannot be machined
No memory available to load programming system data
Workpieces/files which are no longer required can be deleted
130018 File not available OK softkey
EMPIRICAL VALUES
Empirical values file cannot be processed
There is no empirical value file in the data management tree that can be copied into the user branch for
processing.
Notify service
130019 Data transfer in progress! Terminate? Abort/OK softkey
–
–
If an MMC CPU with 8 MB is available, the graphic programming system (WOP) must not be started while the V24
data transfer is in progress.
S By pressing the OK softkey, the V24 data transfer is aborted.
S By pressing the ABORT softkey, WOP is not started.
Applies as from SW 4.4
130020 File has been altered! Lose change? Abort/OK softkey
–
–
File was exited after an alteration with RECALL and without softkey SAVE.
S Press ABORT softkey if further changes are to be made in the edit mode.
S Press OK softkey if the changes are to be lost.
Applies as from SW 4.4
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Note
Scan
Effect
Explanation
Remedy
Note
1 Alarms
1.5.1 Alarm description