Siemens SINUMERIK 840C - Page 143

04/96

Siemens AG 2001 All rights reserved 6FC5198–jAB40
1–135
SINUMERIK 840C / SIMODRIVE 611–D (DA)
144353 ”Spindle %2 not in rotary axis mode !”
144354 ”Setting setpoint for axis %1 not allowed!”
144355 ”Setting setpoint for axis %1 not allowed!”
144356 ”Limit on software limit switch”
144357 ”Spindle in other channel active !”
144358 ”Rotary axis mode not possible for spindle !”
144359 ”Spindle %1 currently being moved as an axis !”
144450 ”@71x: Unable to read R parameters”
144451 ”@71x: Unable to write R parameters”
144452 ”@71x: Unable to copy R parameters”
144453 ”@711: No direction straight line defined”
144454 ”@711: No contour element stored in R para.”
144455 ”@711: No circle element stored in R para.”
144456 ”@711: Circle element exceeds 2 quadrants”
144457 ”@711: No point of intersection available”
144458 ”@710: %1 could not be opened”
144459 ”@710: Wrong control parameter in R%1”
144460 ”@710: NC block from contour %1 cannot be read”
144461 ”@710: Invalid NC block in contour %1”
144462 ”@710: Invalid ident. for direct. of rotation”
144463 ”@710: NC block in contour %1 has error”
144464 ”Circle not programmed in selected plane”
144465 ”DIN: %1”
144501 ”No more memory space available !”
144502 ”No more memory space available !”
144504 ”Error in ’%1’ geometry !”
146000 ”DIN: ... %1 ...”
146001 ”Overlong line cut off”
146002 ”Block not concluded with Line Feed”
146003 ”Jump destination %1 not found”
146004 ”Program SPF%1 not available”
146005 ”Too many SPFs: SPF%1 not opened”
146006 ”M17 not allowed in MPF”
146007 ”M02/M30 not allowed in SPF”
146010 ”Comments/program coordination nested”
146011 ”End of line in comments/program coordination”
1 Alarms
1.5.1 Alarm description