Siemens SINUMERIK 840C - Page 144

04/96

Siemens AG 2001 All rights reserved 6FC5198–jAB40
1–136
SINUMERIK 840C / SIMODRIVE 611–D (DA)
146012 ”Invalid character in block”
146013 ”Too many characters in the block”
146014 ”One point alone is not a permissible number”
146015 ”Block too long: closing brackets inserted”
146020 ”Only R parameters allowed here”
146021 ”Only constant allowed here”
146022 ”Only constant or R parameters allowed here”
146023 ”Only the first sign is considered”
146024 ”Illegal address extension”
146025 ”Illegal value”
146026 ”Illegal R parameter number”
146027 ”Illegal R parameter number”
146028 ”Illegal constant in @ function”
146029 ”Sign in address extension not allowed”
146030 ”Illegal constant”
146040 ”’=’ is missing after target parameter”
146041 ”’R’ must be followed by number or ’=’”
146042 ”Only ’R’, ’P’, or constant allowed here”
146043 ”Division by ZERO”
146044 ”Error in calculation”
146050 ”Illegal beginning of word”
146051 ”Too much information in the block”
146052 ”Value must be an integer”
146053 ”R parameter number not an integer”
146054 ”Illegal word value”
146055 ”Faulty word”
146060 ”%1 word already programmed in block”
146061 ”Too many M functions in the block”
146062 ”Rap.aux.fct. not allowed because %1 value neg”
146063 ”Address extension not allowed for %1 word”
146064 ”Selected D number not available”
146065 ”S word must follow M19”
146066 ”Spindle number not allowed”
146067 ”M function of Group %1 already programmed”
146068 ”Meaning of P word not defined”
146069 ”The block no. is not at the beginning of line”
1 Alarms
1.5.1 Alarm description