04/96
Siemens AG 2001 All rights reserved 6FC5198–jAB40
1–137
SINUMERIK 840C / SIMODRIVE 611–D (DA)
146070 ”Illegal axis address extension”
146071 ”Address with extension not allowed”
146072 ”Illegal address”
146073 ”Address extension not allowed for dwell”
146074 ”Value overflow (negative)”
146075 ”Value overflow (positive)”
146076 ”Main block allowed in program level 0 only”
146077 ”P word must be directly behind G92”
146078 ”P word must immediately follow L–word”
146079 ”Word is not allowed after G%1”
146080 ”G%1: I, J, K, IKA or IKP cannot be allocated”
146081 ”G%1: Same spindle programmed more than once”
146082 ”G%1: I before J is missing”
146083 ”Multiple transform’n select/deselect in block”
146084 ”Selection can only be made in deselected pos.”
146085 ”Valid transformation data set missing”
146100 ”Further alarms in the block are suppressed”
146110 ”Repeated selection of a G group not allowed”
146111 ”Illegal G function”
146112 ”Conflict: @706 <–> G53”
146113 ”G%1: Block cannot be simulated”
146114 ”G%1 interpreted as LF”
146115 ”Smooth retraction requires G40”
146116 ”G40 has already been set by WAB”
146117 ”Function no longer effective”
146118 ”Transmit cannot be simulated”
146120 ”G%1 is not simulated”
146130 ”@ function is not simulated”
146131 ”@ function cannot be simulated exactly”
146132 ”@ function for PLC is not simulated”
146133 ”@ number not allowed”
146134 ”Illegal @ function”
146135 ”Value must be an integer here”
146136 ”Value overflow”
146137 ”Value must be a bit pattern here”
146138 ”Not enough parameters for @ function”
1 Alarms
1.5.1 Alarm description
To Next Page
Loading...
