04/96
Siemens AG 2001 All rights reserved 6FC5198–jAB40
1–138
SINUMERIK 840C / SIMODRIVE 611–D (DA)
146139 ”End of line in @ parameter list”
146140 ”Type of parameter illegal”
146141 ”Illegal sign”
146142 ”Only value 0 or 1 allowed here”
146143 ”Only values 0 to 7 allowed here”
146144 ”No. of machine/setting data not allowed”
146145 ”Type of machine data/setting data illegal”
146146 ”1st parameter: quantity must be positive”
146147 ”Stack limit exceeded/not reached”
146148 ”Source/target is in stack area”
146149 ”Illegal MIB address”
146150 ”MIB cell not initialized”
146151 ”G group function non–modal”
146152 ”R number for result of @713 not allowed”
146153 ”Axis not defined”
146154 ”No IPO parameter exists for axis”
146155 ”@ expression contains errors”
146156 ”Identifier in @3FF cannot be simulated”
146157 ”Type in 3FF data group cannot be simulated”
146158 ”No D number active – cycle alarm 4100”
146159 ”Tool radius = 0 – cycle alarm 4101”
146160 ”Cutter radius too large – cyc. alarm 4102”
146161 ”Tool too wide – cycle alarm 4103”
146162 ”No M03/M04 programmed – cycle alarm 4120”
146163 ”Spindle not in tolerance – cycle alarm 4121”
146164 ”Diam. of fin.part too small – cyc. alarm 4140”
146165 ”Option not available – cycle alarm 4180”
146166 ”Check definition R (Nxxx) – cycle alarm 4200”
146167 ”Thread length too short – cycle alarm 4153”
146168 ”Cycle alarm number not defined ”
146169 ”Only angle No.1 allowed”
146170 ”Only axis 1 to 9 possible”
146171 ”@ position in block invalid”
146200 ”The axis is disabled according to axis MD”
146201 ”G16 block allows only signs in axis word”
146202 ”Axis already programmed in block”
1 Alarms
1.5.1 Alarm description
To Next Page
Loading...
