Siemens SINUMERIK 840C - Page 154

04/96

Siemens AG 2001 All rights reserved 6FC5198–jAB40
1–146
SINUMERIK 840C / SIMODRIVE 611–D (DA)
160004 Data code ... , error ... , 0x ... OK softkey
Startup application
Undefined
Internal system error with stated error parameters
Terminate application and repeat procedure, notify service if necessary.
160005 Function code ... , error ... , 0x ... OK softkey
Startup application
Undefined
Internal system error
Terminate application and repeat procedure, notify service if necessary.
160006 File transfer ID ... , error ... , 0x ... OK softkey
Startup application
Undefined; measuring data lost
S Internal system error
S File transfer error when reading out a measurement buffer with specified error parameters.
Check MMC system configuration and hardware
160007 Measurement/drive type combination not allowed OK softkey
When starting measuring functions
The selected function is not started
The selected function is not possible with the addressed drive type
None
160008 Mode/drive type combination not allowed OK softkey
When starting measuring functions
The selected function is not started
The selected function is not possible with the addressed drive type.
None
160009 Mode/signal type combination not allowed OK softkey
When starting measuring functions
The selected function is not started
The selected signal type is not available
Correct signal selection
160010 Too many function generators operating OK softkey
When function generator is started
Function generator is not started
Only function generator at a time can be active
Stop active function generator and repeat procedure
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
1 Alarms
1.5.1 Alarm description