Siemens SINUMERIK 840C - Page 156

04/96

Siemens AG 2001 All rights reserved 6FC5198–jAB40
1–148
SINUMERIK 840C / SIMODRIVE 611–D (DA)
160019 Invalid tacho adaptation OK softkey
Parameterization/starting startup functions
The startup function cannot be started
See machine data description
Check/correct machine data for tacho adaptation
160020 A measuring function is already active OK softkey
Starting startup functions
The startup function cannot be started
Only one measuring function at a time can be active
Stop previous measuring function and repeat procedure
160022 Illegal bus selection OK softkey
When starting DAC output
DAC output cannot be started
Startup application internal error; it is not possible to access 611D hardware
End application and repeat procedure
160023 Illegal component OK softkey
When starting DAC output
DAC output cannot be started
Signal selection does not correspond to drive components
Correct parameterization
160024 There is no signal OK softkey
Starting DAC output
DAC output cannot be started
The selected signal is not available
Correct signal selection
160025 Protected data area selected (segment) OK softkey
Starting DAC output from memory location
DAC output cannot be started
Selected address area is not allowed
Correct segment parameterization
160026 Protected data area selected (offset) OK softkey
When starting DAC output from memory location
DAC output cannot be started
Selected address area is not allowed
Correct offset parameterization
160027 Illegal offset parameterized OK softkey
When starting DAC output
DAC output cannot be started
Offset value is outside the permissible range
Correct offset value
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
1 Alarms
1.5.1 Alarm description