Siemens SINUMERIK 840C - Page 157

04/96

Siemens AG 2001 All rights reserved 6FC5198–jAB40
1–149
SINUMERIK 840C / SIMODRIVE 611–D (DA)
160028 Illegal shift factor parameterized OK softkey
When starting DAC output
DAC output cannot be started
Shift factor is outside permissible range
Correct shift factor
160029 Missing target hardware OK softkey
When starting DAC output
DAC output cannot be started
–
–
160030 Non-available DAC started OK softkey
When starting DAC output
DAC output cannot be started
A drive module which is not configured has been selected
Select available drive module
160031 Max. number of servo signals exceeded OK softkey
When starting DAC output
DAC output cannot be started
A maximum of 4 SERVO signals can be output through DAC channels
Reduce number of output SERVO signals
160032 Max. number of active DACs exceeded OK softkey
Parameterization/starting DAC output
DAC output cannot be started
Internal startup application error
End application and repeat procedure
160033 DAC busy from other half of two-axis module OK softkey
Parameterization/starting DAC output
DAC output cannot be started
Three DAC channels exist on two-axis modules for both axes
Select other output channel and repeat procedure or stop busy DAC
160034 No axis configured OK softkey
When selecting startup menus for axes
Startup menu for axes disabled
Startup menu for axes needs at least one NC axis
Enter NC axis configuration
160035 No drive module configured OK softkey
Selecting menu for DAC output
Startup menu for DAC is disabled
Menu for DAC output needs at least one 611D module
–
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
1 Alarms
1.5.1 Alarm description