Siemens SINUMERIK 840C - Page 174

04/96

Siemens AG 2001 All rights reserved 6FC5198–jAB40
1–166
SINUMERIK 840C / SIMODRIVE 611–D (DA)
161009 Measurement speed control loop in progress
Startup application speed controller measuring function
–
Speed controller measuring function operational message
–
161010 Please press NC start
Selecting traversing movement during startup application
–
Control waits for traversing function enable with “NC START”
Press NC START
161011 Wait for PLC enable
Selecting traversing movement during startup application
–
Control waits for PLC safety signal
PLC safety signal scan can be deselected with “Enable: internal”
161012 Measuring for circularity test in progress
Start-up application after start of circularity test
–
The control performs circularity test
–
Applies as from SW 4
161013 Measuring for neural QEC in progress
Start-up application after start of neural QEC
–
The control performs neural QEC
–
Applies as from SW 4
161014 Trace function is started
Start-up application after start of SERVO Trace function
–
The control performs SERVO Trace
–
Applies as from SW 4
161015 Trace started ...
Start-up application after recording has started within the control for all active Trace buffers
–
The selected Trace signals are recorded
–
Applies as from SW 4
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Note
Scan
Effect
Explanation
Remedy
Note
Scan
Effect
Explanation
Remedy
Note
Scan
Effect
Explanation
Remedy
Note
1 Alarms
1.5.1 Alarm description