Siemens SINUMERIK 840C - Page 173

04/96

Siemens AG 2001 All rights reserved 6FC5198–jAB40
1–165
SINUMERIK 840C / SIMODRIVE 611–D (DA)
161005 Function abort by NC error ...
Startup application traversing function
The traversing function in question aborted
Traversing function aborted because of system error or operator action.
General error
1 “Emergency stop”
2 “Warm restart”
Mode Group error
17 “Mode change”
Channel error
33 “Not all channels in reset state”
34 “Reset”
35 “Feed hold” or ”feed override = 0”
36 “NC–STOP”
37 “No channel defined”
Axis error
49 “Servo enable”
50 “Parking axis”
51 “Feed hold”
52 “Follow-up”
53 “Axis disable”
54 “Hardware limit switch”
55 “Working area limitation +”
56 “Working area limitation –”
57 “Traversing range +”
58 “Traversing range –”
59 “Error conversion actual value system”
Spindle error
65 “PLC control for spindle”
66 “Spindle reset”
67 “Spindle servo enable”
68 “Setpoint = 0”
69 “Park”
70 “Spindle stop”
If system error occurs, start up control again and repeat procedure
161006 Function generator is running
Startup application function generator
–
Function generator operational message
–
161007 Measurement current control loop in progress
Startup application measuring function current
–
Current controller measuring function operational message
–
161008 Measurement position control loop in progress
Startup application position controller measuring function
–
Position controller measuring function operational message
–
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
1 Alarms
1.5.1 Alarm description