Siemens SINUMERIK 840C Diagnostics Guide

04/96

Siemens AG 2001 All rights reserved 6FC5198–jAB40
1–183
SINUMERIK 840C / SIMODRIVE 611–D (DA)
300001 Configuration error drive number POWER ON
When 611D drive link is being established
611D link is not established
Illegal drive number entered
Enter a drive number between 1 and 15
Applies as from SW 3
300002 Configuration error module type POWER ON
Establishing the 611D drive link
611D link not established
The configured module type does not correspond to the actual module type
Correct 611D module type (1/2 axis module)
Applies as from SW 3
300003 Configuration error bus configuration POWER ON
Establishing the 611D drive link
611D link not established
The configured bus configuration does not correspond to the actual bus configuration (more actual drives as
configured)
Correct 611D configuration; check hardware
Applies as from SW 3
300004 Configuration error meas. cct. components POWER ON
Establishing the 611D drive link
611D link not established
Measuring circuit modules wrongly assigned (submodules missing or incorrect submodule type) or faulty
Replace drive module
Applies as from SW 3
300005 Configuration error drive type POWER ON
Extablishing the 611D drive link
611D link not established
The configured drive type (FDD/MSD) does not correspond to the actual
drive type
Correct configuration or replace modules
Applies as from SW 3
300006 CRC error drive link POWER ON
Cyclic
Machining stops, interlocking of NC START and Mode Group Ready
Interference on 611D drive link
Check control cabinet wiring; consult EMC regulations
Applies as from SW 3
As from SW 6, the alarm 300006 ”CRC error drive link” is displayed only by the drive on which read access could
not be executed. In addition, both error registers from the DCM are displayed for further information on the alarm. If
the information from the error registers is not sufficient to determine a drive number, the alarm is output for the first
drive available.
Scan
Effect
Explanation
Remedy
Note
Scan
Effect
Explanation
Remedy
Note
Scan
Effect
Explanation
Remedy
Note
Scan
Effect
Explanation
Remedy
Note
Scan
Effect
Explanation
Remedy
Note
Scan
Effect
Explanation
Remedy
Note
1 Alarms
1.5.1 Alarm description
07/97

Siemens SINUMERIK 840C Specifications

General

Brand	Siemens
Model	SINUMERIK 840C
Category	Control Unit
Language	English