04/96
Siemens AG 2001 All rights reserved 6FC5198–jAB40
1–225
SINUMERIK 840C / SIMODRIVE 611–D (DA)
Dialog text
What must be done
or
What is wrong
Appears with the
following event
NO RENAME FOR
CYCLES
Renaming cycles is not
possible
––
NO VALUE ENTERED Taking over an input value
(e.g. with the input key)
Input value has the wrong
format
ONLY 1 PROG. NO.
ALLOWED
With MOVE or RENAME
or EXECUTE YES/NO, of
a part program
––
ONLY POSSIBLE AFTER
“RESET”
When entering program
numbers into the
automatic basic display
The NC must be in the
RESET state for safety
reasons. Press RESET or
wait until the current
program is completed
“OPERATOR PROMPT
MACRO BLOCK”
SEVERAL VALUES
When editing via screen
forms using operator
prompt macros
If several fields are
bracketed together in the
display, then only one of
the values can be entered
“OPERATOR PROMPT
MACRO BLOCK” TOO
LONG
When editing using the
screen form with the aid of
the operator prompt
macros
Operator prompt macro
has been incorrectly
configured
“OPERATOR PROMPT
MACRO BLOCK” VALUE
MISSING
When editing via screen
forms using operator
prompt macros
No value has been
entered
OVERSTORAGE ACTIVE When overstoring Wait until previous
overstore operation has
been completed
PROGRAM ALREADY
AVAILABLE
When opening part
programs, copying,
renaming
Select different number
PROGRAM ERASE
PROTECTED
Renaming part program
number
Opening
Reading in via RS232C
(V.24) if already present
and being executed
Complete execution or
reading in
PROGRAM MEMORY
FULL
Inputting part programs
manually or via RS232C
(V.24)
On appearance of the
message programs must
be deleted
PROGRAM NOT
AVAILABLE
Taking over a part program
number during part
program handling
Correct number
PROGRAM NUMBER
NOT ALLOWED
Part program handling Change part program
number
PROGRAM
PRESELECTION
FORBIDDEN (MODE)
Selecting program for
editing in MDA mode
Change mode
PROGRAM
PRESELECTION NOT
ALLOWED
Part program selection
during TEACH IN
Abort TEACH IN (RESET)
SELECT PROGRAM Something is to be entered
in a part program
Select part program
SOURCE PROGRAM
DEFECTIVE
Appears when reading out
a part program
A bit has flipped in the part
program just read (parity
error).
1 Alarms
1.6.2 Listing of dialog texts
To Next Page
Loading...
Need help?
General
