EasyManuals Logo

Siemens SINUMERIK 840C Diagnostics Guide

Siemens SINUMERIK 840C
260 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #49 background imageLoading...
Page #49 background image
04/96
Siemens AG 2001 All rights reserved 6FC5198jAB40
1–41
SINUMERIK 840C / SIMODRIVE 611D (DA)
3000 General programming error Acknowledgement key
S A general programming error which cannot properly be explained has been made in one block in the program.
S Division by 0
S A G function which does not exist has been programmed
S An R parameter which does not exist has been programmed
S No +,, /,” has been programmed in the R parameter chaining
S Range of values has been exceeded with R parameter calculation
S No M19 function allowed with active G96 Constant cutting rate
S Number of decades exceeded (M, S, T, D, H, L, P, F)
S Subroutine number of passes P not programmed directly behind L
S Main block “:” programmed in subroutine
S Two decimal points programmed
S Decimal point programmed with M, S, T, D, H, L, P
S More than 8 decades programmed
S The programmed axis values exceed the travel range limits with the set input resolution
S Auxiliary functions D, F, S or T are programmed with a minus sign.
S SW 3 and higher, block search to a spline interpolation coefficient block
S The F word in G501 exceeds the value range or is negative.
S Check the incorrect block in the Correction block display
S The cursor is placed on the incorrect word, if possible
S The block number of the incorrect block is positioned behind the alarm number in the alarm line.
S Correct the F word accordingly.
Example:
3000 N00101
Channel number
Alarm number
Block number N10 which contains errors
Alarm text
General programming error
Alarm is displayed with reference to channel
Explanation
Remedy
Note
1 Alarms
1.5.1 Alarm description
09/01

Table of Contents

Other manuals for Siemens SINUMERIK 840C

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens SINUMERIK 840C and is the answer not in the manual?

Siemens SINUMERIK 840C Specifications

General IconGeneral
BrandSiemens
ModelSINUMERIK 840C
CategoryControl Unit
LanguageEnglish

Related product manuals