Siemens SINUMERIK 840C Diagnostics Guide

04/96

Siemens AG 2001 All rights reserved 6FC5198–jAB40
1–42
SINUMERIK 840C / SIMODRIVE 611–D (DA)
3001 Number of geometry parameters > 5 Acknowledgement key
When executing a part program
S Machining stops
S More than 2 radii or more than 2 angles have been programmed in the block
S More than 5 geometry parameters such as axes, interpolation parameters, radii, angles, etc. have been
programmed in the block
S Check the faulty block in the “Correction block” display
S If possible the cursor is positioned in front of the faulty word
S The number of the faulty block is after the alarm number in the alarm line
Example:
3000 1 N0010 General programming error
3000 – Alarm number
1 – Channel number
N0010 – Block number “N10” containing errors.
Alarm is displayed with reference to block and channel
3002 Polar coordinates/radius error Acknowledgement key
When executing a part program
S Machining stops
S Interlocking of NC START
S When programming circle/radius, full circle programmed.
S For cylindrical interpolation if:
– Calculated interpolation parameters in the C axis are too large or P factor is too small
– P factor or axial distance to go of the rotary axis for cylindrical interpolation too large
S Check the faulty block in the “Correction block” display
S If possible the cursor is positioned in front of the faulty word
S The number of the faulty block is after the alarm number in the alarm line
Scan
Effect
Explanation
Remedy
Note
Scan
Effect
Explanation
Remedy
1 Alarms
1.5.1 Alarm description
07/97

Siemens SINUMERIK 840C Specifications

General

Brand	Siemens
Model	SINUMERIK 840C
Category	Control Unit
Language	English