EasyManuals Logo

Siemens SINUMERIK 840C Diagnostics Guide

Siemens SINUMERIK 840C
260 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #52 background imageLoading...
Page #52 background image
04/96
Siemens AG 2001 All rights reserved 6FC5198jAB40
1–44
SINUMERIK 840C / SIMODRIVE 611D (DA)
3005 Error in contour definition Acknowledgement key
When executing a part program
S Machining stops
The coordinates in the contour description have been defined so that there is no intersection.
S Too many geometry values have been programmed
S Check the faulty block in the Correction block display
S If possible the cursor is positioned in front of the faulty word
S The number of the faulty block is after the alarm number in the alarm line
Alarm is displayed with reference to block and channel
3006 Wrong block structure Acknowledgement key
When executing a part program
S Machining stops
S Interlocking of NC START
S Approach to reference point with program and specification of the wrong G function or more than one axis, or
an impermissible axis.
S Wrong thread lead parameters with G33
S More than 3 M functions in the block
S More than 1 S function in the block
S More than 1 T function in the block
S More than 1 H function in the block
S More than 4 auxiliary functions in the block
S More than 6 axes + geometry parameters
S More than 5 axes with G00, G01, G02, G03
S More than 2 axes with G10, G11, G12, G13, G110, G111, G112
S More than one radius/angle with G10, G11, G12, G13, G110, G111, G112
S Negative radius with G10, G11, G12, G13, G110, G111, G112
S First programming of polar coordinates G10, G11, G12, G13 or angle/radius
S More than two axes with G02, G03 (circle radius programming)
S G04 programmed with addresses other than X, F or S
S G04 is not programmed in the block by itself
S M19 S is programmed with other functions
S Incorrect circle parameters with G02, G03 axes
S Axis missing with circle radius programming
S Before the first G110 block in the program, a G10/G11 block must have been programmed
S G110 may not be programmed with axes
S Incorrect programming in connection with G176 freeze function
S Either too few measured value memories or none at all have been defined for G720/721/722 via the flexible
memory configuration
S On G511/G522
An F word does not immediately follow G511/G522
G511/G522 is superfluous, because neither a miscellaneous function nor a program coordination
command or an F word output to the PLC is programmed.
S Check the faulty block in the Correction block display
S If possible the cursor is positioned in front of the faulty word
S The number of the faulty block is after the alarm number in the alarm line
S Re G511/G522
Place the F word immediately after G511/G522
Delete G511/G522 F...
Alarm is displayed with reference to block and channel
Scan
Effect
Explanation
Remedy
Note
Scan
Effect
Explanation
Remedy
Note
1 Alarms
1.5.1 Alarm description
07/97

Table of Contents

Other manuals for Siemens SINUMERIK 840C

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens SINUMERIK 840C and is the answer not in the manual?

Siemens SINUMERIK 840C Specifications

General IconGeneral
BrandSiemens
ModelSINUMERIK 840C
CategoryControl Unit
LanguageEnglish

Related product manuals