EasyManuals Logo

Siemens SINUMERIK 840C Diagnostics Guide

Siemens SINUMERIK 840C
260 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #57 background imageLoading...
Page #57 background image
04/96
Siemens AG 2001 All rights reserved 6FC5198jAB40
1–49
SINUMERIK 840C / SIMODRIVE 611D (DA)
3026 Fixed-text component too large Acknowledgement key
S On display selection via softkey
S Not all fixed texts are displayed
The programmed fixed text part in the display description is too large.
Using the NC workstation, reduce the fixed text part of the display or split up the contents over several displays.
3027 Graphics section too large Acknowledgement key
S On display selection
S No graphics display
The programmed graphics part in the display description is too large
(max. 4 Kbytes).
Using the NC workstation, reduce the fixed text part of the display or split up the contents over several displays.
3029 Window beyond configuring area Acknowledgement key
S On display selection
Display build-up is aborted when the window of a display being configured is outside the configuring area.
Additional subdisplays can be configured in a screen. The subdisplay windows can be moved in the configuring
area. As a result the window may have been moved outside the configuring area configuring error.
Configure the window movement so that it does not leave the configuring area (see also alarm 3037).
3030 Cursor memory not available Acknowledgement key
S On display selection
The display selected is treated as though there were no cursor memory.
The cursor memory programmed in the selected display is incorrect (illegal number, or too large).
Redefine cursor memory with NC workstation, since the cursor memory has the task, when a display is recalled,
of putting the cursor back where it was when the display was removed.
3031 Too many part programs
On display selection
Slower display build-up and processing time may result.
The configuring engineer has called up too many display descriptions with part program parts
Only incorporate a maximum of 5 part programs in the display descriptions if possible. The alarm need not be
acknowledged as it is only for information.
Applies to SW 1 only
3031 Error: NCK softkey text to MMC Acknowledgement key
S When selecting the menu
S The softkey text is not displayed
An error has occurred while transferring the softkey text from NCK to MMC.
Activate notebook for I code and send message to
System support together with notebook entry (system program change required)
Applies as from SW 2
3032 Variable component too large Acknowledgement key
S When selecting a display with a softkey
S None
The programmed variable display part of the display description is too large.
S Check display with NC workstation, and if necessary regenerate
S Reduce variable display part
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Note
Scan
Effect
Explanation
Remedy
Note
Scan
Effect
Explanation
Remedy
1 Alarms
1.5.1 Alarm description

Table of Contents

Other manuals for Siemens SINUMERIK 840C

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens SINUMERIK 840C and is the answer not in the manual?

Siemens SINUMERIK 840C Specifications

General IconGeneral
BrandSiemens
ModelSINUMERIK 840C
CategoryControl Unit
LanguageEnglish

Related product manuals