04/96
Siemens AG 2001 All rights reserved 6FC5198–jAB40
1–55
SINUMERIK 840C / SIMODRIVE 611–D (DA)
3094 Error in compensation data Acknowledgement key
On POWER ON/warm restart
Interpolatory compensation (IKA) is not executed, an IKA already active is ended.
It is not possible to convert the error curves because the input data are incorrect.
1. Only one of the start and end pointers is 0. Both must be 0 or <> 0.
2. End pointer is not greater than start pointer
3. Within an error curve section, the interpolation position (n+1) is less than or equal to the interpolation position (n)
4. The straight line slope within an error curve section is >= 45 degrees
5. Both pointers of the table are zero
6. Intermediate point or intermediate value not calculated
The block number indicates which IKA point is affected
Correct the compensation data
3095 Handwheel 1 – wire breakage Acknowledgement key
S Cyclic
S It is no longer possible to traverse the axes in the normal way using the handwheel.
S The alarm is only relevant for handwheels with differential signal evaluation
S Check the handwheels
Eliminate the hardware fault
S If necessary, connect wire jumper on CSB, if handwheel is not connected, to avoid triggering alarm
3096 Handwheel 2 – wire breakage Acknowledgement key
S Cyclic
S It is no longer possible to traverse the axes in the normal way using the handwheel.
S The alarm is only relevant for handwheels with differential signal evaluation
S Check the handwheels
Eliminate the hardware fault
S If necessary, connect wire jumper on CSB, if handwheel is not connected, to avoid triggering alarm.
3097 Illegal handwheel function Acknowledgement key
G27 programmed with active DRF
Setting data 564* not provided with values
S Interlocking of NC START
Deselect DRF
Alarm is displayed with reference to channel
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Remedy
Note
1 Alarms
1.5.1 Alarm description
09/01
To Next Page
Loading...
Need help?
General
