Siemens SINUMERIK 840C Diagnostics Guide

04/96

Siemens AG 2001 All rights reserved 6FC5198–jAB40
1–58
SINUMERIK 840C / SIMODRIVE 611–D (DA)
3164 Axis conversion error Acknowledgement key
S While executing in AUTOMATIC, MDA or Teach In mode
S Machining stops
S Interlocking of NC START
S The alarm is displayed in channel and block.
S Wrong entries in axis converter list (SD)
– Axis name not entered
– Axis does not exist
Correct axis converter list
Alarm is displayed with reference to block and channel
3166 Program coordination wrong Acknowledgement key
While executing a part program
S Machining stops
Addressed channel has not been defined or is not enabled
Change channel addressing
Define or enable channel
Alarm is displayed with reference to block and channel
3167 T/H word not acknowledged Acknowledgement key
Cyclic
None
S The target channel is not enabled in the PLC MD (signals from channel)
S Routing in target channel has not yet been acknowledged by the user
The current routing and/or error must be acknowledged through the PLC program before the next routing is assi-
gned.
3200 Program coordination syntax wrong Acknowledgement key
When executing a part program
Interlocking of machining
Syntax error: invalid command mnemonics
invalid modification parameters
Correct the faulty command
Alarm is displayed with reference to block and channel
3201 Program coord. too many parameters Acknowledgement key
When executing a part program
Interlocking of machining
More command parameters have been programmed than are permitted in the command description.
Correct the faulty command
Channel-specific
3202 Program coordination area violation Acknowledgement key
When executing a part program
Interlocking of machining
One or more command parameters violate the permitted lower and upper limit values
Correct the faulty command
Alarm is displayed with reference to block and channel
Scan
Effect
Explanation
Remedy
Note
Scan
Effect
Explanation
Remedy
Note
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Note
Scan
Effect
Explanation
Remedy
Note
Scan
Effect
Explanation
Remedy
Note
1 Alarms
1.5.1 Alarm description
07/9707/97

Siemens SINUMERIK 840C Specifications

General

Brand	Siemens
Model	SINUMERIK 840C
Category	Control Unit
Language	English