04/96
Siemens AG 2001 All rights reserved 6FC5198–jAB40
1–59
SINUMERIK 840C / SIMODRIVE 611–D (DA)
3203 Program coord. illegal character Acknowledgement key
When executing a part program
Interlocking of machining
Illegal separators are in the coordination command.
Correct the faulty command
Alarm is displayed with reference to block and channel
3204 Program coord. command incomplete Acknowledgement key
When executing a part program
Interlocking of machining
Parameters or closing brackets are missing in the programmed command
or channel no. = 0
Correct the faulty command
Alarm is displayed with reference to block and channel
3205 Program coord. R parameter error Acknowledgement key
When executing a part program
Interlocking of machining
S An error occurred while programmed R parameters were being substituted
Correct the faulty command
Alarm is displayed with reference to block and channel
3206 Program coord. symbol. paras. not allowed Acknowledgement key
When executing a part program
Interlocking of machining
With the exception of the R parameters, no symbol. parameters are permitted
Correct the faulty command
Alarm is displayed with reference to block and channel
3220 Change from G176 G175 Acknowledgement key
S When executing a part program
S Activated freeze function is terminated leading to G175 function.
During an activated freeze function for angle of rotation, zero offset or length compensation, the ZO group was
changed or the D No. was changed, an angle of rotation offset was activated or a G53 programmed.
These functions result in termination of the “Freeze” function and a change to the G175 function.
S Check program blocks and correct
Channel-specific
3225 Invalid plane specification Acknowledgement key
Before executing a part program
S Processing stops
The plane assignment (cube) and the axis definitions in the channel do not correspond.
Check NC MD 548* 550*552*
Alarm is displayed with reference to channel
Scan
Effect
Explanation
Remedy
Note
Scan
Effect
Explanation
Remedy
Note
Scan
Effect
Explanation
Remedy
Note
Scan
Effect
Explanation
Remedy
Note
Scan
Effect
Explanation
Remedy
Note
Scan
Effect
Explanation
Remedy
Note
1 Alarms
1.5.1 Alarm description
07/97
To Next Page
Loading...
Need help?
General
