Siemens siprotec 7SJ63 - Page 356

Operators Tools
7-10 7SJ63 Manual
C53000-G1140-C120-1
From the
Device Front
If erasure is desired, first press the key. The 0$,10(18 appears. The first menu
item $QQXQFLDWLRQ is marked.
Press the key to enter the $1181&,$7,21 menu (see Figure 7-1).
Using the key, select the item 6HW5HVHW, and switch to the sub-menu using the
key.
Here, select the message group to be erased using the key, and then press the
key. See Figure 7-12.
Password No. 5 (for setting changes) is required at this point. After entering the pass-
word and confirming with the key, the safety question “$UH\RXVXUH?” ap-
pears. The response “<(6” is the default (Figure 7-12). Confirm with the key, if
the message group should really be erased. If the message group should not
be
erased, press the key so that the response “12” is highlighted, and confirm this an-
swer with the key. Before confirming with the key, the responses can be tog-
gled between “<(6” and “12” using the and keys. Alternatively, the key can
be pressed to cancel the erasure procedure.
Figure 7-12 Erasing Messages from the Operator Control Panel
From PC with
DIGSI
®
4
When operating with DIGSI
®
4, the device messages can be saved on the hard drive
of a personal computer before they are erased from the device. To do this, follow ex-
actly the same steps taken to retrieve the messages. Instead of double clicking on the
message group in the message list to open the group, select the option )LOH → 6DYH
in the DIGSI
®
4 window menu bar. DIGSI
®
4 then automatically creates a directory for
the messages — if one does not exist — and saves the message group in this direc-
Note:
When Trip Log is erased, the fault records and counters for network fault number and
indication data number are set to zero. If, however, a fault record is erased, the
counters are unaffected.
MENU
ENTER
ENTER
ENTER
ENTER ENTER
ESC
6(75(6(7

!(YHQW/RJ
!7ULS/RJ
Etc
Press the associated number key to se-
lect the messages to be erased.
$UH\RXVXUH"
!<(612
Confirm “<(6” with the key and com-
plete the erasing of the selected messag-
es, or switch to “12” with the key and
cancel the erasure with the key.
ENTER
ENTER
ENTER
3:3DUDPHWHU&KDQJH"
 
Enter Password No. 5 (for setting change)
and confirm with
ENTER
:
www . ElectricalPartManuals . com